Gmc Theft Deterrent System Reset
The General Motors Corporation (GMC) Theft Deterrent System is designed to protect vehicles from unauthorized access. This system is comprised of a variety of components, including an ignition lock cylinder, a keyless entry system, an immobilizer, and a security system. In order to ensure maximum security, the GMC Theft Deterrent System must be reset after any changes are made to the vehicle or the security system. This resetting process is relatively simple and can be performed at home in a few simple steps.
Step-by-Step Guide to Resetting a GMC Theft Deterrent System
The GMC Theft Deterrent System reset process is a straightforward process that can be completed at home. In order to reset the system, the following steps must be followed:
Step 1: Disconnect the Vehicle's Battery
The first step in resetting the GMC Theft Deterrent System is to disconnect the vehicle's battery. This can be done by locating the negative terminal of the battery and using a wrench to loosen and remove the nut that holds the terminal in place. Once the nut is removed, the terminal can be pulled away from the battery and the vehicle's electrical system will be disconnected.
Step 2: Reconnect the Vehicle's Battery
Once the battery has been disconnected, it must be reconnected in order to reset the GMC Theft Deterrent System. This can be done by first re-installing the negative terminal to the battery and then tightening the nut that holds the terminal in place. Once the nut is tight, the vehicle's battery will be reconnected and the GMC Theft Deterrent System will be ready to be reset.
Step 3: Locate the Theft Deterrent System's Control Module
The next step in resetting the GMC Theft Deterrent System is to locate the Theft Deterrent System's control module. This module is typically located under the dashboard on the driver's side of the vehicle. Once the module is located, it must be unplugged from the vehicle's wiring harness in order to reset the system.
Step 4: Plug the Control Module Back In
Once the control module has been unplugged from the vehicle's wiring harness, it must be plugged back in to reset the GMC Theft Deterrent System. This can be done by simply inserting the plug into the wiring harness and making sure that it is firmly in place.
Step 5: Start the Vehicle
Once the control module is plugged back in, it is time to start the vehicle and reset the GMC Theft Deterrent System. This can be done by inserting the key into the ignition and turning the key to the "on" position. After the vehicle has been started, the Theft Deterrent System should be reset and the vehicle should be ready to use.
Step 6: Test the System
After the GMC Theft Deterrent System has been reset, it is important to test the system to ensure that it is functioning properly. This can be done by inserting the key into the ignition and attempting to start the vehicle. If the system is functioning properly, the vehicle should start without any problems.
Conclusion
Resetting the GMC Theft Deterrent System is a relatively simple process that can be completed at home in just a few simple steps. By following the steps outlined above, anyone can reset the system in order to ensure maximum security for their vehicle.
Service Theft Deterrent System? - Page 6 - 2014-2018 Silverado & Sierra
Vehicle Anti Theft System Reset Override Technique-GMC Sierra or
FIX: GM/Silverado/Duramax Security Passlock Relearn/Reset Procedure
