2015 Jeep Wrangler Oil Change
The 2015 Jeep Wrangler is one of the most iconic off-road vehicles ever created. It is a rugged and dependable vehicle that is designed to tackle any terrain. However, like all cars, it requires regular maintenance to keep it running its best. One of the most important maintenance tasks is an oil change, which should be done every 3,000 to 5,000 miles or as recommended by the manufacturer. This article will explain the steps involved in changing the oil in a 2015 Jeep Wrangler.
Step-by-Step Guide to Oil Change on a 2015 Jeep Wrangler
Gather the Necessary Supplies
Before you start any maintenance task, it is important to make sure you have the necessary supplies. In order to change the oil on your 2015 Jeep Wrangler, you will need an oil filter, a new oil pan, and an oil drain plug. You will also need an oil filter wrench and a socket set. Additionally, you may want to have a funnel, a container to collect the used oil, and some shop towels on hand.
Remove the Oil Plug and the Oil Filter
Once you have gathered the necessary supplies, you can begin the oil change process. The first step is to locate the oil plug and the oil filter. The oil plug is located at the bottom of the engine and the oil filter is usually located on the side of the engine. Using the socket set, loosen and remove the oil plug and the oil filter. Be sure to place the oil plug and filter into the container to collect the used oil.
Replace the Oil Filter and the Oil Plug
Once the oil plug and filter are removed, it is time to replace them. Take the new oil filter and place it in the same position as the old one. Use the oil filter wrench to tighten the filter. Next, take the new oil plug and place it in the oil pan. Using the socket set, tighten the plug.
Drain and Refill the Oil
Once the oil plug and filter are replaced, it is time to drain and refill the oil. Place the oil drain pan beneath the engine and remove the oil plug. Allow the oil to drain completely. Once the oil has drained, replace the oil plug and remove the funnel. Using the funnel, add the recommended amount of oil to the engine.
Check and Clean the Oil Plug and Filter
Once you have refilled the engine with oil, it is important to check the oil plug and filter. Using the shop towels, check the oil plug and filter for any signs of damage or wear. If there is any damage, it is important to replace the parts before continuing.
Start the Engine and Check the Oil Level
Once the oil plug and filter have been checked and cleaned, it is time to start the engine and check the oil level. Start the engine and let it run for a few minutes. Once the engine has been running for a few minutes, turn it off and check the oil level. If the level is too low, add more oil to the engine.
Dispose of Used Oil and Parts
The final step in changing the oil in the 2015 Jeep Wrangler is to dispose of the used oil and parts. Take the container that was used to collect the used oil and parts to a local auto parts store or oil recycling center. They will be able to properly dispose of the used oil and parts.
Conclusion
Changing the oil in a 2015 Jeep Wrangler is a relatively simple process that can be completed in a few hours. It is important to make sure you have the necessary supplies before beginning the process. Additionally, it is important to dispose of the used oil and parts properly. Following these steps will ensure your Jeep Wrangler is running its best.
Oil Change - Jeep Wrangler 2015 - YouTube
2015 Jeep JK Wrangler Oil Change - YouTube
Jeep Wrangler JK 2007 to 2016 How to Change Engine Oil - Jk-Forum
