Maytag Washer Stuck On Sensing
Maytag is a trusted name in home appliances and is a popular choice for washers. But even with its reputation for durability, you may find yourself in a situation where your Maytag washer is stuck on sensing. This can be a frustrating problem, especially when you need to do a load of laundry. Fortunately, there are some steps you can take to troubleshoot and try to fix the problem yourself.
Troubleshooting a Maytag Washer Stuck on Sensing
The first step you should take when your Maytag washer is stuck on sensing is to check the lid switch. If the lid switch is not working properly, the washer will not be able to properly detect the load size. To check the lid switch, open the washer lid and press down on the lid switch. If you hear a clicking sound, then the switch is working properly. If you don’t hear a clicking sound, then the switch may be faulty and will need to be replaced.
Check Water Levels and Cycle Settings
The next step is to check the water levels and cycle settings of your washer. If the water level is too low, the washer may not detect a full load. To check the water level, open the washer lid and make sure that the water level is at least one inch above the bottom of the washer tub. If the water level is too low, adjust the water level setting on the washer control panel.
Next, check the cycle settings on the washer. If the cycle settings are incorrect, the washer may not be able to detect the load size. Make sure the cycle settings are correct and that the washer is set to the proper cycle. If the settings are incorrect, adjust them accordingly.
Check for Blockages and Kinks in the Hoses
The next step is to check for blockages or kinks in the hoses connected to the washer. If there are blockages or kinks in the hoses, they may be preventing the washer from detecting the load size. To check the hoses, disconnect them from the washer and check for any blockages or kinks. If there are any, remove them and reattach the hoses.
Check for an Unbalanced Load
Another common cause of a Maytag washer stuck on sensing is an unbalanced load. An unbalanced load can cause the washer to become stuck on sensing as it struggles to detect the load size. To check for an unbalanced load, open the washer lid and redistribute the load inside the washer tub. Make sure the load is evenly distributed and that the clothes are not bunched together.
Run the Washer Through a Rinse and Spin Cycle
If the above steps do not fix the problem, you may need to run the washer through a rinse and spin cycle. This will help reset the washer and may help clear any errors. To do this, simply select the rinse and spin cycle on the washer control panel and press start.
Check the Washer’s Control Panel
Finally, you may need to check the washer’s control panel. If there are any error codes displayed, they can help you diagnose the problem. Refer to your washer’s user manual for instructions on how to interpret the error codes.
Conclusion
If your Maytag washer is stuck on sensing, the first steps you should take are to check the lid switch, water levels, cycle settings, hoses, and unbalanced load. If these steps do not fix the problem, you may need to run the washer through a rinse and spin cycle or check the washer’s control panel for any error codes. With some troubleshooting and a little bit of patience, you should be able to get your washer working again.
Maytag Bravos XL600 gets stuck in sensing mode! Help - YouTube
Maytag Bravos Washer Stuck On Sensing: 5 Quick Fixes
Maytag Bravos Washer Stuck On Sensing: 5 Quick Fixes
